VisionStat Plus MA-BCKS-7.0 Manuel d'utilisateur télécharger pdf (Page 16)

Mobile Awareness

Fig 31: SE Sensor Mounted Vertically

Fig 30: SE Sensor Mounted Horizontally

The SE Mount is an enhanced mounting method that further

protects the Sensors while providing alternative mounting op-

tions. The solid rubber compound SE Sensor Mount is de-

signed to securely and conveniently attach the SenseStat Sen-

sor Element to your vehicle. To facilitate the installation, 2 each

#6-32 Stainless Steel Hex Screws (2 inches in length) are pro-

vided, along with the appropriate washers and hex nuts. To

properly affix the SE Sensor Mounts, use only the hardware

provided, making sure to use the Flat Washer (0.375 inch out-

side diameter) in the front of and in back of each unit. If the

screw is not long enough, be sure to use #6-32 Stainless Steel

Socket Hex Screws only.

1) Begin by examining the rear of the vehicle for the best location to secure the Sen-

sors. Below, in Figure 30 and Figure 31, are examples of how the SE Sensor Mount

can be oriented either horizontally or vertically. Depending on any space con-

straints, decide which orientation is best suited for your vehicle. If you encounter any

difficulty in doing so, please contact Mobile Awareness Technical Support for assis-

tance.

Sensor Installation (SE Version)

Fig 28: Sensor Angle Metal

Bracket (oriented “UP”)

Fig 27: Rear of Metal Bracket

Assembly (oriented “UP”)

Fig 26: Sensor

“UP” Indicator

Fig 29: SE Mount

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Pas de commentaire

VisionStat Plus MA-BCKS-7.0 Manuel d'utilisateur Page 16