19
VisionStat Plus Video Monitoring and Obstacle Detection Sensor System
1) Depending on the vehicle type, select an appropriate location to mount the water-
tight ECU on the rear undercarriage of the truck chassis (refer to Figure 38). Make
sure the ECU is installed 4 inches (10cm) away
from any objects (metal or electrical) that may af-
fect the wireless transmission (if applicable).
2) Secure with the two (2) enclosed mounting bolts
(M6X10). Be sure to secure the ECU tightly so to
prevent the unit from becoming loosened due to
road vibration.
3) Securely tighten the watertight Sensor connectors
to the same numbered ECU cable connectors la-
beled S1, S2, S3 & S4.
NOTE: The ECU location should be selected so
that the four (4) Sensor cables are in reach of the
desired Sensor mounting locations. If needed, exten-
sion cables are available by contacting Mobile Awareness.
ECU Installation Location & Sensor Connection
Fig 38: Mounting the ECU
Having all four Sensors in line, on
the same plane, provides the best
result. If you break the Sensor con-
figuration up, for example two on
top and two on bottom, you create
a bigger gap between the Sensors,
causing a large blind zone area.
This blind zone area can lead to
objects or people being undetected
by the Sensors.
Fig 37: Sensor Configuration and Blind Zones
A) Initial Test: With the vehicle in park and your foot on the brake, shift the vehi-
cle into reverse. The display (which remains blank at all other times) will turn on and
begin the Automatic Self-Test. It will be helpful to have an observer assist you in
testing the unit the first time by having them carefully walk behind the vehicle. When
doing so, each of the individual four (4) Sensor icons will indicate (by flashing) when
the assistant is closet to a particular Sensor. The distance in feet and inches will
also indicate when the individual is within 8 feet of a Sensor.
B) Volume Adjustment: Use the Monitor’s menu to adjust the desired volume setting.
C) Backing Test: Once the above is completed, test the system by placing the
vehicle in reverse with nothing behind it for at least 8 feet. The VisionStat Plus sys-
tem will turn on and run a Self-Test. Once completed (takes about 2 seconds), the
icon and distance measurement will not display since no object is within 8 feet of the
Sensors. Begin backing up and as soon as an object is detected the Sensor icons
and distance measurement will appear on the Monitor. One of the four (4) Sensor
icons will be flashing (the one that is closest to an object) and the distance to that
object is displayed as well.
NOTE: Audibly indicates only when an object is within 5’7” of Sensor 2 & 3 (two
center Sensors) and 3’3” inches of Sensor 1 & 4 (two outer Sensors).
Installation Test
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels