VisionStat Plus MA-BCKS-7.0 Manuel d'utilisateur télécharger pdf (Page 23)

VisionStat Plus Video Monitoring and Obstacle Detection Sensor System

Symptom Possible Causes and Solution

No Picture Ensure that Cameras are connected properly.

No Sound Ensure the volume is turned up to a desired level

and not muted.

Dark Picture Ensure brightness and contrast are adjusted cor-

rectly. Check whether the environment temperature

is too low.

No Color Adjust color settings.

Upside down or inverted picture Use the remote control horizontal/vertical selection

switch to set proper orientation. This can also be

done using the Menu button on the Monitor and

going to System settings.

No reversing function Check that the correct corresponding color coded

trigger wire is connected properly. For example,

the rear Camera is typically connected to the

BROWN 4-pin connector, so the BROWN trigger

wire would need to be used to toggle the Monitor to

that channel, in this case, Channel 3.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

VisionStat Plus MA-BCKS-7.0 Manuel d'utilisateur Page 23